Safety Notice regarding safety harness tethers

The Marine Accident Investigation Branch (MAIB) is carrying out an investigation into the fatal man overboard accident on board the yacht CV30, which was taking part in the Clipper Round the World Yacht Race.

The yacht was on the third leg of the Clipper Round the World Yacht Race having left Cape Town on 31 Oct 2017 bound for Fremantle, Western Australia.

On 18 Nov 2017, the yacht was approximately 1,500nm from Fremantle, when a crew member fell overboard. He was attached to the yacht by his safety harness tether. The hook at the end of the tether that was clipped to a jack-line, deformed and released resulting in him becoming separated from the yacht. He was recovered unconscious onto the yacht but sadly could not be resuscitated.


The crew member was using a three-point webbing tether attached to the integral harness of his lifejacket that allowed him to clip on to the yacht with a short or long tether.
A safety issue identified during the investigation was that the hook on the end of crew member's tether had become caught under a deck cleat (see Figure 1 below), resulting in a lateral loading that was sufficient to cause the hook to distort (see Figure 2 below) and eventually release.

Both images are copyright MAIB.

The tether hook was of a conventional design and quality of build, and was commonly used by manufacturers of safety harnesses and tethers that were certified under ISO12401.
When loaded longitudinally, the tether can withstand a load of over 1 tonne. However, when loaded laterally a tether hook will deform at much less load. It is important that tether hooks remain clear of obstructions and are free to rotate to align the load longitudinally.


To prevent the strength of a safety harness tether becoming compromised in-service due to lateral loading on the tether hook, the method used to anchor the end of the tether to the vessel should be arranged to ensure that the tether hook cannot become entangled with deck fittings or other equipment.

Safety with DIY Antifouling

The RYA is concerned that the future quality and availability of antifouling paints, in particular for pleasure craft use, is in doubt due to the requirement for all biocidal products to undergo a stringent authorisation procedure under the Biocidal Products Regulation (EU) No.528/2012 (BPR). More details are here and the page will open in a new tab/window:

RYA Notes on Future of Antifouling

Links to external, or third party Web sites, are provided solely for visitors' convenience.
Links taken to other sites are done so at your own risk and Cargreen Yacht Club Ltd accepts no liability for any linked sites or their content.
When you access an external Web site, keep in mind that Cargreen Yacht Club Ltd has no control over its content.

The British Coatings Federation (BCF) has issued a number of information leaflets:


Antifouling Safety Leaflet

Fuller Guide to Antifouling

Further information from the BCF is here.

This website uses cookies to allow navigation around the site. By using and further navigating this website you accept this.
See the Information > Privacy page for more details of personal information used by linked sites.